Cleco Panel Holding Kit with 3/16" Holders 8" This kit comes with three

This kit comes with three 3 lb bars:

Spiral thread allows wheel to spin up tapered shaft when motor is turned on

We represent quality products that we stand behind because we actually use them in our own polishing shop

These are the original and only units made in the USA by Lancaster Pump

Cleco Panel Holding Kit with 3/16" Holders 8" This kit comes with threeOriginally this type of panel holder was developed in the late 1920's for holding aircraft skin in place for riveting. Today coach builders and NASCAR body men use them daily. These are great for holding panels in place for fitting or welding. To use, just drill a hold (to fit holder size) through both the underlying original panel and the overlapping replacement panels and insert the holder. Each holder has 25lbs of holding pressure. The side grip